![]() ![]() ![]() Just follow the simple steps below to switch your UI:įirmware 2.1.0 and newer have the following settings by default. ![]() The application now offers an injection method which takes over Ray's OpenSprinkler UI. Starting with firmware 2.0.3, an option has been added to change the Javascript URL path for the UI. To contribute to any language please visit our Transifex page.įor current discussion about the project please refer to the forums.įor advanced users, the application supports authentication (HTTP Basic) and SSL for devices behind proxies. Language translation is crowd sourced using Transifex. The application runs completely within the user's browser (or webview) and communicates directly with the OpenSprinkler. I’ll let you know because I don’t have much time. I may come out with something for home assistant. I’ve been reading the opensprinkler bee API and it is well described and seems quite easy to access and change programs. I set up the password, then went to log in to the app. I’ve just installed my opensprinkler bee 2 and it works great with latching valves for my garden. wifi: ssid: wifissid password: wifipassword logger: sprinkler: - id. Continue holding B3 until the LCD displays ‘Setup Options’. For seasonal changes, its easier to use the multiplier to adjust the. Took a while, but I eventually got the e-mail with a link to set up my password. then press and hold push button B3 while powering it back on. The application is written in Javascript and HTML/CSS. Purchased an OpenSprinkler the other day and tried to set up an account and the app so everything is ready to go when it gets here. Furthermore, Dan Kimberling's OSPi program is also supported. The application has been tested and is compatible with all versions of the Unified firmware for both Arduino and Raspberry Pi. You can use any combination of GPIO pin you would like as far as you use components supported by the code (libraries) and you change the pins. This application interfaces with OpenSprinkler. This application is available for free from the following app stores: Biggest issue is without having the factory password you cannot access the app. Designed to allow manual control, program management (view, edit, delete and add), initiation of a run-once program, viewing device status, adjusting rain delay, changing of OpenSprinkler settings and much more. The unit would not connect to router even after wired. This app only works with the OpenSprinkler controller which must be installed and setup on your home network. © 2013-2016 Samer Albahra ( mobile interface for the OpenSprinkler irrigation device. Welcome to the OpenSprinkler application. OpenSprinkler App Official Site | Support | Changelog Welcome to the OpenSprinkler application. ![]()
0 Comments
Leave a Reply. |